Publicidad
Idiomas disponibles
Idiomas disponibles
For address setting, press the Yes/No-buttons until the display shows "A001" and set the desired address via
the Yes/No-buttons.
Controlling:
After having addressed all TG-5, you may now start operating these via your lighting controller.
Note:
After switching on, the TG-5 will automatically detect whether DMX 512 data is received or not. If the data is
received, the control LED flashes. If there is no data received at the DMX-input, the control LED lights up
permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the TG-5.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control channel 1 - Colour-wheel
Linear colour change following the movement of the slider. In this way you can stop the colour-wheel in any
position.
DMX-value
Feature
0-9
White
10-20
Green
21-31
Red
32-41
Cyan
42-52
Bright green
53-63
Magenta
64-73
Bright blue
74-84
Yellow
85-95
Green
96-105
Pink
106-116
Blue
117-128
Orange
129-190
Scroll
191-193
Sound-controlled
194-223
Forwards rainbow effect with decreasing speed
224-225
No rotation
226-255
Backwards rainbow effect with increasing speed
26/55
51785855_V_1_3.DOC
Publicidad
