Husqvarna LC 247SP Manual De Instrucciones página 83

Lamp indicator on
battery.
Constant red light
Flashing red light
Constant green light
Flashing red and
green light
Spark plug
NOTICE! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the
piston/cylinder.
• If the machine is low on power, difficult to start or runs
poorly at idle speed: always check the spark plug first
before taking other steps.
• If the spark plug is dirty, clean it and check the
electrode gap. For more information, see the
"Technical data" section. Replace if necessary.
Adjusting the drive belt
If the drive feels sluggish, it may be due to a slipping
clutch and the clutch cable will then have to be adjusted.
Finely adjust the wire using the adjuster screw.
• To tension the wire and increase speed, screw the
adjustment screw counterclockwise.
Variable Speed
(LC347V, LC347VI, LC353V,LC353VI)
Adjust the speed of the above models by moving the
control lever rearward for slow drive and forward for fast
drive. Note that the lowest position can be engaged only
MAINTENANCE
Cause
Battery charging.
Battery too warm and
will start to charge
when correct
temperature has
been reached.
The battery is fully
charged.
Battery damaged
and must be
replaced.
when the machine is running. If the machine is running
and the lowest position cannot be engaged, the control
must be adjusted by unscrewing the adjustment screw.
Make sure the wires are not tensioned too tight. If the
lawn mower starts to drive withtout the clutch lever is
beeing operated, extend the wire.
• To extend the wire and reduce speed, screw the
adjustment screw clockwise.
If the drive still feels slow, the belt will have to be replaced.
Contact an authorised service workshop.
Air filter
• Remove the air filter cover and take out the filter.
• An air filter that has been in use for a long time cannot
be cleaned completely. The filter must therefore be
replaced with a new one at regular intervals. A
damaged air filter must always be replaced.
• When reassembling, make sure that the filter
completely seals against the filter holder.
Clean the paper filter
• Clean the filter by knocking the filter against a flat
surface. Never use solvent with petroleum, for
example, kerosene, or compressed air to clean the
filter.
Cleaning the foam plastic filter
(LC 247, LC 247S)
• Remove the foam plastic filter. Wash the filter well in
tepid soapy water. After cleaning, rinse the filter well in
clean water. Squeeze out and allow the filter to dry.
NOTE! High pressure compressed air can damage
the foam. After cleaning the filter should be oiled using
engine oil. Wipe away excess oil by pressing a clean
cloth against the filter.
Oil change
IMPORTANT! Allow the machine to cool. Hot oil can
cause severe burn injuries.
• Empty the fuel tank.
• Unscrew the oil filler cap.
• Place a suitable vessel to collect the oil in.
• Drain the oil by tipping the engine so that the oil runs
out through the filler pipe. When the machine is tilted,
make sure the air filter always is placed in the highest
position. Ask where you can dispose of surplus
engine oil at your local petrol station.
• Fill with new engine oil of the right quality. See
instructions in the section "Technical data".
• Please see the engine Operator's Manual for more
information.
Fuel system
• Check that the fuel cap and its seal are not damaged.
• Check the fuel hose. Replace if necessary.
–
English 83