Publicidad
Idiomas disponibles
Idiomas disponibles
36
SPECIFICATIONS
Problem
Power is not turned on
The door does not open
when the cycle pauses or
finishes
The wash cycle time is
longer than usual
It is musty or moldy in the
tub
SPECIFICATIONS
Model WM2650H*A
Description
Electrical requirements
Max. water pressure
Dimensions
Net weight
Max. spin speed
Possible Causes
Is the power cord plugged in properly?
y
Has a house fuse blown, a circuit breaker
y
tripped, or a power outage occurred?
Is the temperature in the tub too high?
y
Is the water level in washer high?
y
Is the washing machine overloaded? Are other
y
options added to the wash cycle?
Has the incorrect detergent been used?
y
Did you clean the tub periodically?
y
Front-Loading Washer
120 VAC @ 60 Hz.
14.5 - 116 PSI (100 - 800 kPa)
68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
3
11
27" (W) X 29
/
" (D) X 38
4
181.9lb (82.5kg)
1200 RPM
Make sure that the plug is secured in a
y
grounded 3-prong, 120 V (60 Hz) outlet.
Reset the circuit breaker or replace the fuse.
y
Do not increase the fuse capacity. If the
problem is a circuit overload, have it corrected
by a qualified electrician.
The washing machine has a safety lock built
y
into the door to prevent burning. Leave the
door closed and wait until the door lock icon
disappears from the display.
Allow the washer to complete the
y
programmed cycle, or run the DRAIN & SPIN
cycle to drain the water.
This is normal. The washing machine
y
automatically adjusts the cycle time for the
amount of laundry, water pressure, water
temperature, and other operating conditions.
Use only HE (High-Efficiency) detergent
y
recommended for a front-loading washing
machine.
See page 29, clean the inside and outside of
y
the washing machine periodically.
/
" (H), 51" (D with door open)
16
Solutions
Publicidad
