Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Connecting the Power
The main power ON/OFF (0/I) switch is located on the back of the heater.
To connect the power supply to the heater, push this switch to the ON (I) position.
There is a "D" sound and the screen will display in full for 3 seconds,
then heater enters into standby mode.
If you wish to disconnect the power supply,
push ON/OFF (0/I) button again and switch to OFF (0).
Reading the Digital Display
Referred to in manual
Full Sun Icon
Working at full power = 2000W
Half sun Icon
Working at low power = 1000W
Snowflake Icon
Anti-Frost Function
Window Icon
Window open detection function
Timer Icon
Reverse timer function
[ ]
Child Lock Icon
Child lock function
d1
D1
Day 1/ Monday
d2
D2
Day 2/ Tuesday
d3
D3
Day 3/ Wednesday
d4
D4
Day 4/ Thursday
d5
D5
Day 5/ Friday
d6
D6
Day 6/ Saturday
d7
D7
Day 7/ Sunday
Remote Control Buttons
1.
On/Standby
2.
Power Setting
3.
Window open detection button
4.
Timer button
5.
Program
6.
Mode button
7.
Up-arrow button
8.
Down-arrow button
Battery: 1 x CR2025 3V
Meaning
1
2
3
4
8
Control Panel Buttons
Buttons
On/ standby button
Power setting button
Up-arrow button
Down-arrow button
1.
Turning the Heater On and Off
To switch on the fan heater, press the on/standby button once.
t will immediately power on and you will hear it running, and it will start to blow out warm air.
OFF: To switch the heater off again, press the same on/standby button to put it into standby mode.
2.
Set the current day and time
Set the day of the week
a)
Switch the heater on.
b)
Long-press the timer button for 3 seconds.
c)
The screen will first display
d)
Press the up-arrow or down-arrow to set the day of the week
it currently is from d1, d2, d3, d4, d5, d6, d7.
e)
After selecting the day, press the timer button once to confirm.
Set the clock
f)
Next, the heater enters into the time/clock setting.
A numbered digit flashes on the screen.
g)
Set the hour: Press the up-arrow button or down-arrow button to set the
current correct hour among 00-23 in the cycle.
5
prog
h)
When you have chosen the hour, press the timer button once to confirm.
i)
Set the minutes: Press the up-arrow button or down-arrow button to set the
current correct minutes from 0-59.
6
mode
j)
Press the timer button once to confirm.
k)
Finally, when both the hour and minutes have been set,
7
press the timer button once to confirm and save the settings.
After setting the time, allow the digital screen to return back to the standard screen.
8
To check if the current day and time is set currently, press the timer button once; the screen will
automatically show the information in this order: Day, Hour, Minutes in turns within 1 second of each
other, then, the screen will switch back to the ambient temperature display.
Referred to in manual as
Setting up the heater
d1
and start to flash.
9
Publicidad
