D-Link DCS-932 Guía De Instalación Rápida página 4

Ocultar thumbs Ver también para DCS-932:

Idiomas disponibles

TROUBLESHOOTING

SET-UP AND CONFIGURATION PROBLEMS

1. HOW DO I RESET MY DCS-932 TO FACTORY DEFAULT SETTINGS?

- ensure the dcs-932 is powered on.

- push and hold a paperclip in the reset hole for 10 seconds, then release it. the camera will then

reset to factory default settings.

2. HOW DO I CONFIGURE MY DCS-932 WITHOUT THE CD?

- connect your pc to the router using an ethernet cable.

- log on to d-link support site http://support.dlink.com.tw. download the setup Wizard se utility

from the dcs-932 section under technical support.

- Install and run setup Wizard utility se.

- the default username is 'admin'. the default password is blank.

- If you have changed the password and can not remember it, you will need to reset the dcs-932

to set the password back to blank (leave the field blank). If the dcs-932 cannot find a dHcp

server, the default Ip address is http://192.168.0.20.

3. WHAT CAN I DO IF MY DCS-932 IS NOT WORKING CORRECTLY?

- try using the wizard on the included cd.

- to make sure your hardware is installed correctly, make sure that:

• the front led is lit solid green

• your Internet connection is working

• your router's lan & Wan connections are ok

• your router supports upnp

• your camera is on the same network as your pc

• both your pc and camera have a working Internet connection

- If your camera is still not working, check your router and make sure it is using the latest

firmware.

4. I DO NOT HAvE A ROUTER. HOW DO I INSTALL MY DCS-932?

- connect the camera directly to the computer's ethernet port.

- assign your computer a static Ip address within the same range as the camera, such as

192.168.0.x.

- access and set up your camera via the default Ip address of http://192.168.0.20.

- For more information, please refer to the user manual.

DCS-932