Option Buttons
Your washer features several additional cycle options
that customize cycles to meet your individual needs.
To use these options, select the desired option after
selecting the desired cycle.
After selecting the desired cycle and settings, press
the cycle option button(s) for the option(s) you would
like to add. The button will light when that option is
selected. If the selected option is not allowed for the
selected cycle, the chime will sound twice to alert you
and the LED will not illuminate.
NOTE
• To protect your garments, not every feature is
available with every cycle.
Steam
Adding the Steam option to a wash cycle helps
provide superior cleaning performance. By using hot
steam, the fabrics will get the cleaning benefits of a
very hot wash.
WARNING
• Do not touch the lid during Steam cycles. The lid
surface can become very hot. Allow the lid lock
to release before opening the door.
• Do not attempt to override the lid lock mecha-
nism or reach into the washer during a Steam
cycle. Steam can cause severe burns.
NOTE
• The Steam option cannot be used with all cycles.
• The Steam option is automatically deselected if
Turbo Wash™ is selected for the Normal, Heavy
Duty, Sanitary, and Bright Whites™ cycles.
• Steam may not be clearly visible during the Steam
cycles. This is normal. Too much steam could dam-
age clothing.
• Do not use Steam with delicate fabrics such as
wool, silk, or easily discolored fabrics.
Cold Wash
This option saves energy by using cooler water while
increasing the wash and rinse times to maintain wash
performance.
NOTE
• Wash time will increase up to several minutes with
this option.
• For best wash results, only wash small loads (less
than 8 lb.) with this option.
Delay Wash
Once you have selected the cycle and other settings,
press this button to delay the start of the wash cycle.
Each press of the button increases the delay time by
1 hour, for up to 19 hours. Once the desired delay
time is set, press the Start/Pause button to start the
delay time.
NOTE
• If the Start/Pause button is not pressed to begin
the delay time, the washer will automatically shut off
after 60 minutes and all cycle settings will be lost.
Signal
The washing machine plays a melody when the
wash cycle has finished. The volume of the melody is
adjusted using the Signal button.
• Press the Signal button repeatedly to adjust the
volume of the signal.
• The signal can be turned On or Off. When the LED
on the button turns off, the signal is off. The signal
volume can be adjusted at any time as long as the
washer is turned on.
31
OPERATION