Details Of Data Input / Output; Connecting A Computer - Sokkia SET300 Manual Del Operador

23. DETAILS OF DATA INPUT / OUTPUT

23.1

Connecting a Computer

Commands input at a computer instruct the SET to carry out measurement and
output data. Connect the input / output connector on the SET and a data collector
or a computer using the dedicated interface cable (optional accessories).
Comms setup: "22.1 Modificación de las opciones del instrumento" •
Settings in Config Mode, Command operation: "23.2 Two-way
Communication Functions Command - Data Input / Output Format -", Data
output: "10.4 Medición de ángulos y volcado de los datos", "11.3 Medición
de distancia y volcado de datos", "21. VOLCADO DE LOS DATOS DE UN
TRABAJO"
• All the data is output in SDR33 format from SET to external equipment.
• Choose the right interface cable for the computer you are connecting
"26.2 Accesorios opcionales"
• Output data
External data collection from the SET uses RS-232C baseband signals.
• Input / output connector pin assignments
Pin No.
1
2
3
4
5
6
Signal name
SG (GND)
NC
SD (TXD)
RD (RXD)
NC
NC
95