Publicidad
Idiomas disponibles
Idiomas disponibles
6) Photo electric safety beam
Photo Beam disabled
7) Open / stop / close terminals
The O/S/C facility can be used for an external push button switch to operate the opener. The switch must have voltage free
normally open contacts (Figure 18)
Photo beam connection (optional) – Figure15, Figure16
Switch control connection (optional) – Figure15
Remark:
1) Flash (Caution Light) should be less than 25W.
2) PB (External Push Button) should be " NO".
Opening your life
NOTE: Make sure the photo beam has been correctly installed and use
Normally Closed contacts to the accessory terminals of the opener (Figura
15, Figura16)
Photo Beam enabled
Also note that the photo beam function must be disabled if NO photo
beams are tted, otherwise the door cannot be closed, and the LED will
blink once time as an indication.
a) Press and hold the DOWN button until 11 appears on the display. To
enable the photo beam option press UP again, the display will indicate a
H(enabled) or press DOWN button to disable (display 11) the option.
b) Press SET to con rm the set.
Opening your life
11
Raptor
RP120
Code:
Figure 15
www.accessmatic.com
Publicidad
