Publicidad
Idiomas disponibles
Idiomas disponibles
Before taking into operation for the first time, the installation has to be approved by an expert!
Master/Slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the TC-5 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can be
used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device, when F6 and F4
or F5 is set to Yes and controls all other slave-devices, which are to be connected to the master-device via a
balanced microphone lead. Connect the DMX OUT-jack with the DMX IN-plug of the next device.
For the slave, set the DMX starting address to A001 and the buttons F4, F5 and F6 to No. You can connect
as many slave-devices as you like.
DMX-512 connection / connection between fixtures
Starting address 1
120 Ohms
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
DANGER TO LIFE!
Projector 1
Sensitivity
Power supply
230 V AC/ 50Hz
the fixtures will not work at all, or will not work properly.
Projector 2
Starting address 3
Sensitivity
Power supply
230 V AC/ 50Hz
DMX-512 Controller
24/53
Projector 3
Starting address 5
Sensitivity
Power supply
230 V AC/ 50Hz
00026765.DOC, Version 1.3
Publicidad
