Mox C40 Serie Instrucciones Y Advertencias Para El Instalador página 22

13 Belt tension (fig. 16)
Check the belt tensioning once every six months; if necessary, tighten the M8 nut with a wrench at the end, leaving a minimum safety and compensation
slack between the spring's coils (1 mm).
14 Electrical connections (fig. 17)
Fig.17: Comply with the instructions for the installed electronic control unit.
15 Parameters menu
Preparation
Keep the carriage locked as in the image, open and close the leaf manually and make sure that the carriage engages with the shuttle.
Turn on the power supply. The interior light stays on for several seconds and the LED display shows at the same time a number from 99 to 11.
99
Then, the operating panel switches to standby.
11
-- The display shows "--".
Automatic closing and opening setting
Attention! Make sure that the safety terminal is CLOSED before programming the stroke.
p1 Press and hold the SET button, until "P1" is displayed.
0p Press SET to show "OP".
0p Press and hold the UP button", "OP" will flash. The door opens..
CL When the door reaches the opening position, immediately release the UP button and press SET. The display shows "CL".
Press and hold the DOWN button, "CL" will flash. When the door reaches the closing position, immediately release the DOWN button and press
CL
SET.
OP
The door opens and closes automatically to map the requirements for the opening and closing sensitivity force.
CL
-- The display shows "--" to confirm that the setting is complete.
p 1
.
PORTA CHIUSA
x6 s
DOOR CLOSE
C L
. .
Inserting or modifying a transmitter
s Press CODE to display "SU".
s Press a button on the transmitter, SU switches off, then release and press again the same button, "SU" flashes.
-- The display shows "--" to indicate that the setting is complete. Repeat the steps until encoding maximum 20 different transmitters and/or buttons.
f When 20 codes have been memorised, "FU" flashes, or, if encoding errors are anticipated, all memorised codes must be deleted.
DL Press and hold CODE for more than 8 seconds, "DL" flashes: all codes have been deleted.
22
0 p
. . .
CHIUSURA CHIUSA RILASCIARE
CLOSING CLOSE
RELEASE
0 p
. .
APERTURA APERTA
OPENING OPEN
-
0 p
. .
APERTURA
OPENING
C - -
.
C
RILASCIARE
RELEASE
-
C L
. .
. .
CHIUSURA
CLOSING
If C -.-. is displayed, the ride has not been
acquired correctly. Re-programming
.
L
. .
- -
. .