Publicidad
Idiomas disponibles
Idiomas disponibles
Cabinet Installation
1. Open the window. Mark a line on
center of the window sill(or desired air
conditioner location).
Carefully place the cabinet on the
window sill and align the center mark
on the bottom front with the center
line marked in the window sill.
(See Fig.1)
2. Pull the bottom window sash down
behind the upper guide until it meets.
(See Fig.2)
NOTE:
• Do not pull the window sash down so
tightly that the movement of Frame
Curtain is restricted.
3. Loosely assemble the sill support
using the parts in Fig. 3.
4. Select the position that will place the
sill support near the outer most point
on sill (See Fig. 4)
5. Attach the sill support to the cabinet
track hole in relation to the selected
position using 2 Type A screws in
each support (See Fig. 4).
6. The cabinet should be installed with a
very slight tilt (about
downward toward the outside (See
Fig. 5).
Adjust the bolt and the nut of sill
support for balancing the cabinet.
7. Attach the cabinet to the window sill
by driving the screws
through the front angle into window
sill.
8. Pull each Frame curtain fully to each
window sash track, and repeat step 2.
INDOOR
INDOOR
1
/
"(12.7mm))
2
(Type B)
Sill support
12
Upper Guide
Front Angle
Window Sash
Upper guide
Foam-pe
11
Cabinet
Frame Curtain
1
Foam-pe
8
Bolt
3
Screw (Type A)
Screw (Type B)
6
Screw (Type B)
2
Window sill
Fig. 1
Fig. 2
OUTDOOR
Sill Support
2
Nut
Fig. 3
4
5
Cabinet
Fig. 4
OUTDOOR
Sill support
2
Sash track
Front Angle
6
Fig. 5
Publicidad
