Safety Instructions - cecotec CONGA 1390 Serie Manual De Instrucciones

Remote control
1. LED display
2. Back home
3. Direction buttons
4. Power level
5. Water intensity/time settings
6. Schedule
7. ON/OFF button
8. Mode (only operates from standby mode)
Battery
• The remote control requires 2 x AAA-type batteries.
• If the remote control is used near the charging base, the device might not recognize the
command.
• Remove the batteries from inside the remote control if the robot is not going to be used
for a long time.

2. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance. Keep this instruction manual
for future reference or new users.
• This product must be used in accordance with the directions in this instruction manual.
Cecotec cannot be held liable or responsible for any damages or injuries caused by
improper use.
• Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance and that the wall outlet is grounded.
• This product can only be disassembled by qualified personnel.
• Do not touch wires, power supplies or power adapters with wet hands.
• Keep the robot away from clothing, curtains and any other similar materials.
• Do not sit or place heavy or sharp objects on top of the appliance.
• Do not operate the appliance close to heat sources, flammable substances, wet surfaces
where it can fall or be pushed into water or allow it to come into contact with water or
other liquids. Do not operate outdoors.
• Do not use the charging base if it has a damaged cord or plug or if it is not operating
properly. In case of fault or malfunction, contact the official Technical Support Service of
Cecotec.
• Do not operate the device on tables or chairs where it could fall.
• Do not operate the product in places where the temperature is below 0 ºC or above 40 ºC.
• The appliance can only be operated with the provided battery and power adapter. The
ENGLISH
6
7
8
1
2
3
4
5
21