Battery Charging - cecotec CONGA 1390 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
When the device connects to the Wi-Fi, the white light will turn steady.
If the device fails to connect, the white light will blink faster.
3.
Battery indicator light
The light will turn red when the battery is low.
The light will switch from blue to red alternately during charging.
The light will turn steady blue when it is totally charged.

BATTERY CHARGING

1.
Charging base
Place the charging base against the wall.
Remove any obstacle from around the charging
base, following the safety distances shown on the
below picture:
Always turn the robot's power switch ON before
placing it on the charging base.
2.
Connection
a.
other to the power supply. (Fig. a)
b.
the remote control for the robot to automatically return to the charging base. (Fig. b).
Note: if the robot's battery is low during operation, it will automatically return to the charging
base before running out.
3.
Battery's service life
In order to lengthen the battery's service life:
Allow the robot to charge for 5 hours during the first charge.
Charge the robot as soon as possible when the battery is low.
If the robot is not going to be used for a long time: fully charge the battery, switch the
robot off and store it in a cool and dry place.
If the robot has been stored for a long time, allow it to charge for 5 hours before
operating it again.
Plug one of the adapter ends into the robot's charging socket and the
While the charging base is connected to the power supply, press
A
ENGLISH
on
B
25

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido