GE JP939 Manual Del Propietário página 9

How to Lock the Cooktop
IMPORTANT: As a convenience, you can
CONTROL CONTROL
LOCK LOCK
lock the entire cooktop at any time when
it is not in use or before cleaning.
Locking the cooktop will prevent surface
units from being turned on accidentally.
To lock the cooktop:
Touch and hold the CONTROL LOCK pad
for 3 seconds.
A two-beep signal will sound, the word
"LOCK" will appear in the TIMER display,
and the Control Lock light will turn on,
How to Operate the Kitchen Timer
ON
NOTE: The kitchen timer will NOT turn off the
OFF
surface units when the time reaches 00:00.
TIMER
To operate the kitchen timer, use the
pads below the TIMER display.
OR
Touch the ON/OFF pad and then touch
the (+)/(-) pad to choose the desired time
setting. If the (+)/(-) pad is held for
several seconds, the timer will increase or
decrease at a faster rate.
Using the Pan Detection Feature
PAN
This feature automatically turns off a
surface unit after 60 seconds if a pan is
absent from the surface unit. The power
level display will flash until the surface
unit is turned off when the control
detects the absence of a pan.
To activate and deactivate pan detection for
all surface units:
Touch the PAN pad. (At least one surface
unit must be on.) The display will flash
"PAN ON" when the pan detection
feature is on.
A signal will sound and a light next to
the PAN pad will indicate whether the
feature is active. If the light is on, pan
detection is on, and if the light is off,
Using Pan Sizing
PAN
This feature is only used on the dual
surface unit when the pan detection
feature is enabled. When a small pan is
placed on the surface unit, the small
surface unit will activate. When a pan
larger than 6.0 inches is placed on the
surface unit, the large surface unit will
automatically activate. This feature may be
overridden for a single cooking session
while leaving the pan detection feature
active (see Dual Surface Unit section).
www.GEAppliances.com
indicating that the cooktop is locked.
If the cooktop is locked while the surface
units or timer are in use, they will
automatically turn off.
To unlock:
Touch and hold the CONTROL LOCK pad
again for 3 seconds.
A two-beep signal will sound, and the
Control Lock light will go out, indicating
that the cooktop is unlocked.
After you have chosen your desired time,
the timer will automatically start to count
down from the hours/minutes that you
have selected. When the timer counts
down to the last minute, the control will
beep once and the timer will count down
in seconds until 00:00. Then the control
will beep twice every five seconds until
the timer is turned off. Touch the ON/OFF
pad to turn the timer off.
pan detection is off. When the pan
detection feature is disabled, the pan
sizing feature is also disabled.
NOTES:
s
For this feature to work properly, the
pan diameter must be greater than 4.0
inches and centered on the surface
unit.
s
This feature may not operate properly
with rounded, curved or warped pan
bottoms (see the Types of Cookware
section).
s
This feature will not work with glass
cookware (see the Types of Cookware
section).
To turn off this feature and the pan detection
feature:
Touch the PAN pad.
The light next to the pad will go out,
indicating that pan features are turned off.
NOTE: The pan must be centered over the
surface unit for this feature to work properly.
9