Descargar Imprimir esta página

Parkside PRSA 20-Li A1 Traduccion Del Manual De Instrucciones Originales página 11

Fresadora de corte recargable 20 v

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 105
WARNING!
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or
someone similarly qualified.
CAUTION!
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Cutting bit set
Original accessories included in delivery
For cutting
r Cutting bit 3.18 mm (1/8")
o Cutting bit 6.35 mm (1/4")
Inserting a cutting bit
Press the spindle locking button 6 and hold it
down. The spindle lock must enter into the shaft.
Undo the union nut 5 by turning it anticlock-
wise with the open-ended spanner i.
Release the spindle locking button 6.
Now insert the cutting bit.
This must be inserted to a depth of at least
20 mm.
Press the spindle locking button 6 and hold it
down. The spindle lock must enter into the shaft.
Tighten the union nut 5 using the open-ended
spanner i.
Release the spindle locking button 6.
PRSA 20-Li A1
Connecting the extraction nozzle
Loosen the screw 3. Remove the depth stop 4.
Attach the extraction nozzle t to the appli-
ance in the same way as the depth stop 4.
Retighten the screw 3. You can use the height
of the installed extraction nozzle t to deter-
mine the insertion depth of the cutting bit, as
with the depth stop 4.
Attach an approved dust and sawdust extractor
to the extraction nozzle t.
Changing the collet chuck
Press the spindle locking button 6 and hold it
down. The spindle lock must enter into the shaft.
Undo the union nut 5 by turning it anticlock-
wise with the open-ended spanner i until the
collet chuck z can be removed. The collet
chock 3.18 mm z is inserted inside the collet
chuck 6.35 mm u.
Insert a collet chuck z/u.
ATTENTION! Do not tighten the union nut 5
with the open-ended spanner i unless a cutting
bit is fitted. Otherwise, the collet chuck may be
damaged.
Release the spindle locking button 6.
GB │ IE
 7

Publicidad

loading