Uline H-9618 Instrucciones De Montaje página 5

11. Remove stringer. Fasten back side of assembly to
workbench top with five 8-15 x 0.625" tapping screws
through exposed holes along inner/outer rails.
(See Figure 10) Replace stringer as in step 6.
Figure 10
12. Place control box at center of assembly against
inner/outer rails on the exposed side. Secure control
box to table top using Phillips head drill and two
10-12 x 2" tapping screws. (See Figure 11)
Figure 11
13. Connect one motor cable into end of control Box
slot marked "1" and second motor cable into slot
marked "2." Then connect other end of motor cables
to each adjustable height leg by inserting cable
into white cable slot. (See Figure 12)
Figure 12
PAGE 5 OF 39
ASSEMBLY CONTINUED
14. Connect the power for the control box by inserting
power cord into slot designated as "AC."
(See Figure 13)
Figure 13
15. The inner/outer rails feature a cable management
tray. Tuck the loose cords into the cable
management tray to hide them. (See Figure 14)
Figure 14
16. Position mounting bracket for programmable handset
at the front edge of the table top in desired position.
Bracket should face upward. Secure to table top using
Phillips head drill and two 8-15 x 0.625" tapping screws.
(See Figure 15)
Figure 15
1121 IH-8184