Publicidad
Idiomas disponibles
Idiomas disponibles
SEQUENCER menu (cont.)
ROTATION
Rotate the pattern by the specified number of steps.
AUTOMATION
Submenu that allows you to automate the parameters of the sequencer. Press the SMALL encoder to
access this submenu. Each parameter can be assigned a source, such as a random value, the value of
an output, or the voltage from the CV input.
- (NONE)
There is no automation.
CV - (CV / CV RAND)
The parameter value will change depending on the input voltage CV. With CV RAND, the
value will change to a random one each time the CV input registers a pulse (>3.3V).
ZE - (ZE CV / ZE RAND)
When the sequence returns to step 1, the value will change to the voltage read at that mo-
ment in the CV input or to a random value (RAND).
WAVE
The parameter will change its value based on the waveform amplitude of the selected chan-
nel in real-time.
ZE W
When the sequence returns to step 1, the parameter will change its value based on the
waveform amplitude of the selected channel.
Rotate the SMALL encoder to select the different types. To change the parameter to edit (ON/OFF, RE-
SET, RATIO, DIR...), press the SMALL encoder and, without releasing it, turn it.
Once the changes are made, press the SMALL encoder to exit the submenu.
SAVE
You can save the channel configuration in one of the 32 available slots. Press the SMALL encoder to
access this menu. To select the slot (or slots) to save, turn any encoder and press the button of any
encoder. A number will appear below the slot, indicating that the channel has been saved in that slot.
For example, if you see a 7, it means that channel 7 will load the information saved in that slot when
the module is powered on.
The slots in the SEQUENCER and SHAPE menus are independent. For more information about the PATCHES
menu, please refer to page 35.
R
15
Magerit
28
Publicidad
