37
Update
To update KAIROS, it is first necessary to put it in update mode. To do this, hold down the LEFT button and, without
releasing it, press the RESET button (located on the gear below the SMALL encoder). You can use a paper clip or
any thin utensil to press it. Once RESET is pressed, you can release the LEFT button. The display will "freeze". Ano-
ther way to put it in update mode is to turn off the rack, press the LEFT button and, without releasing it, turn on
the rack.
Next, connect the module to your computer using a USB-C cable. Then go to the following page:
https://magerit.es/downloads/?lang=en
(use Chrome v89 or higher). Select KAIROS and click "Connect". Choose
the port of your module and finally click "Update!". Wait a few seconds and when you get the success message in
the browser, reset the module (you can also turn it off and on).
Magerit