MCU LED DISPLAY DIAGRAM
1. Battery Level Bar -
a. Green means full level
c. Red means low input, you have to recharge the battery at once
2. Load Level Bar -
a. Red means the inverter is almost overloaded ,not available for more loads
b. Yellow means half level of loads but still acceptable
c. Green means working in good condition (low loads without worries)
3. Input Voltage Display
4. Output Voltage Display
5. High Temperature Warning Indicator -
The symbol of
6. High/Low Input Voltage Warning Indicator -
a. High input voltage warning - symbol of
flickers,input voltage display shows 14.5V or more,plus audible alarm then shutdown
b. Low input voltage warning - symbol of
flickers,input voltage display shows 10.5V or less,plus audible alarm then shutdown
7. Overload / Short-circuit Warning Indicator -
a. Overload warning - symbol of
outputplus audible alarm ,then shutdown
b. Short circuit warning - same as above
8. Frequency Display
9. Power On/Off Indicator -
a. Green - working
b. Red - faulty, without output
BATTERY
+
1
v
v
6
lights up (red color) ,plus audible alarm then shutdown
t
www.pooxtra-inverter.com
5
t
-
9
8
b. Yellow means half level
v
lights up(red), battery level bar
v
lights up(red), battery level bar
lights up(red), load level bar flickers, no
TM
3
2
4
7
9