FRONT PANEL
(PXA1000PSW/1000MSW/1500PSW/2000PSW/2000MSW)
Ground Terminal
• Power Switch — This switch controls AC output of the inverter.
• AC Outlets —
These outlets can supply up to 8 amps at 120V AC 60 Hz (for 1000Watts) ;
12.5 amps at 120V AC 60 Hz (for 1500Watts) ;
15 amps at 120V AC 60 Hz (for 2000Watts)
• USB Power Ports — These power ports can supply 5 volts at 2.1A for charging
or powering tablets, e-readers, smartphones, and other small electronic devices.
• Ground Terminal — For attaching an insulated safety ground wire. This safety
wire is for protecting personnel if there is an unlikely failure in either the cabling
or enclosure insulation. Grounding the inverter enclosure ensures personnel
safety should a DC cable problem occur. During the installation procedure, the
Ground Terminal is connected either to a vehicle chassis or to the negative DC
terminal of the battery. Do not directly connect this ground connection to the
negative DC terminal of the inverter. If the inverter installation is located in fixed
location, the safety wire can be connected to earth's ground.
• Remote Control — Wired remote ON/OFF control (See Remote Control Below).
INSTALLATION / ENVIRONMENTS
AC Outlets
www.pooxtra-inverter.com
Power Switch
TM
USB Power Ports
Remote Control
5