Publicidad
Idiomas disponibles
Idiomas disponibles
Faucet
1. Place gaskets under spout.
Pass the supply hoses and mounting
studs through the mountin holes until
the spout comes to rest.
2. Orient the spout as needed. From
below the mounting surface, place the
crescent shaped washer over the mount-
ing studs as shown.
Fasten the mounting nuts to the studs
to secure the spout.
Tighten with wrench as needed.
Connect the hoses to the supply lines.
The left hose (marked with red band)
connects to the hot water supply. The
right hose connects to the cold water
supply.
Tighten with wrench as needed.
3. Insert the drain lift rod through the
opening in the back of spout.
INSTALLATION PROCEDURE
4
Spout Body
Gasket
Mounting
Studs
Spout Body
Mounting Studs
Washer
Spring Washer
Mounting Nut
Supply Hoses
Drain
Lift Rod
Publicidad
