Descargar Imprimir esta página

Bestron COPPER COLLECTION DF402CO Manual Del Usuario página 33

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
OPERATION - Using the baskets
The frying baskets can be used in many different combinations:
For small portions, just use one small basket (max. 750gram).
For larger portions, or large snacks, use the large basket (max 1500gram).
For frying two different kinds of foods at the same time, use the two small baskets (max. 2x 750 gram)
together.
CLEANING AND MAINTENANCE - Replacing the oil or liquid fat
The quality of the oil or liquid fat deteriorates every time you use the deep fryer. For this reason you will need
to replace the oil or liquid fat at regular intervals. Topping up the oil or liquid fat will not improve the quality. Use
good quality oil or liquid fat.
ATTENTION: Never using solid fats (blocks)
ATTENTION: Only use oil or liquid fats specifically suitable for frying
Replace the oil or liquid fat when:
It becomes darker in color
It becomes thicker in consistency
small air bubbles are seen that take a long time to disappear (in new, fresh liquid fat the air bubbles are
large and they also disappear rapidly).
The fried food has an unpleasant or strange taste or smell
The appliance emits more smoke than usual
CLEANING AND MAINTENANCE - General
Clean the appliance and the loose parts thoroughly
after each use:
1. Disconnect the plug from the wall socket.
2. Switch off the deep fryer by turning the On/
Off - temperature control dial fully to the left.
3. Allow the deep fryer to cool.
4. Store the power cord in the compartment at
the back.
5. Remove the lid and the baskets.
6. Remove the inner pan and pour the oil or
liquid fat into a receptacle. Preference is given
to handing in frying oil and liquid fat to your
municipality. Then it can be reused for other
purposes.
7. Remove the remaining oil using absorbent
paper kitchen towel.
8. Thoroughly clean the inside of the pan and
baskets with hot water with a little washing-up
liquid. Do not use scourers. Dry everything thoroughly.
9. Clean the housing with a damp cloth, if necessary with an additional couple of drops of washing-up liquid.
After cleaning, dry the housing thoroughly.
10. Reassemble the appliance.
ATTENTION:
If the control panel is not slid correctly into both of the guides then the device will not operate properly or won't
operate at all. Verify that you have fitted the control panel with the heating element in the correct manner (see
figure 4).
Keep the appliance in a dry place.
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to clean
the appliance.
Never immerse the heating element unit in water or another liquid and never place it under flowing water.
33
EN

Publicidad

loading

Este manual también es adecuado para:

Copper collection df402co xl