Belkin F5U302ea Manual Del Usuario página 25

Maintenance
If neither of those steps work, try resetting your Hub by
unplugging the power-supply connector from the back
of the Hub, waiting a few moments, and then plugging it
back in. Note: After doing this, you must repeat the cable-
security setup.
3. I have a device installed but I still can't seem to connect
to it. What should I check before contacting Technical
Support?
Have you completed the one-time cable-association
procedure? If so, please verify that the device you set up
appears in the "Devices" page of the Wireless USB Control
Center. If it does not, try the security-setup process again,
following the instructions carefully. You will be prompted
when the process has completed successfully. Do not
unplug the cable until you receive this message.
Try moving the devices very close together to determine
if a connection can be made. Once the connection has
been made, begin moving them further apart to determine
the maximum operating distance for your environment.
Note that this distance could be reduced by large solid
objects placed between the two devices, such as a wall or
refrigerator. The best setup places the devices in a line-of-
sight orientation.
Check the Windows Device Manager and verify that
there are no "Unknown" devices that are related to the
installation of the Wireless USB Hub. If they are related
to the installation of the Wireless USB Hub, please try
reinstalling the drivers or restarting the "Found New
Hardware" Wizard to see if it will install the drivers properly.
If this does not clear up the issue, please contact Technical
Support.
5427ea_F5U302ea_man.indb 21
EN-21
1
2
3
4
5
6
12/19/2007 3:40:34 PM