Publicidad
Idiomas disponibles
Idiomas disponibles
English
11 Interior light
(not provided in all models)
A switch is built into appliances equipped with lighting.
When the appliance is opened the light goes on
automatically and switches off automatically when
closed.
The lamp is protected with a transparent cover.
Strictly use 15 W max. replacement bulbs.
To replace the light bulb,first remove the two shade-
fastening screws,then unscrew the troubled bulb by
turning counterclock wise and replace with a new one of
the same specification,and then remount the shade and
fasten it up with the screws.
12 Resolving faults on your own
High quality manufacturing processes and use of latest
cooling and freezing technology will principally ensure
trouble-free function of your appliance.
If you suspect any fault, before contacting the approved
after-sales service directly or via your dealer, make sure
you have observed all instructions and advice in this
user manual.
Repairs by the approved after-sales service,centre/agent of
faults that have occurred because of non-adherence to the
information and advice given in this manual,will be charged to
the customer and are not covered by your dealer's guarantee.
Attention
The compressor (M) (also known as motor) must not
operate continuously.
It is controlled by the thermostat which you set with the
temperature
control
(FIG.4).
automatically when the set temperature in the storage
compartment exceeds and switches off automatically
when the correct temperature is reached again.
Noise can be heard from all compressor – cooling
system when the compressor is switched on. This noise
is produced when the motor in the compressor operates
and also by refrigerant flowing in the cooling system
circuit. These noises are normal and do not indicate
any functional trouble.
In unheated rooms and in cold weather condition
condensation can build up on the outer walls of the
appliance. This does not mean trouble and disappears
when the weather becomes warmer.
Calling the Customers Support Service
Call the approved after-sales service only, if after analy-
sis of possible trouble/fault factors you cannot find any
cause for the defect or do not have the means to
eliminate the trouble.
Therefore first check under "Trouble shooting"
All manuals and user guides at all-guides.com
It
switches
on
5
Instruction for use
13 After-sales service
Consult the enclosed guarantee card or the separately
enclosed after-sales centres list, to see which company
is responsible for servicing your appliance. If several
after-sales centres are mentioned on the list, select the
nearest one to you.
If no after-sales service centres list is enclosed with
your appliance, contact your dealer.
Publicidad
