Brill 400 GB Manual Del Usuario página 19

sport venues, on roads and in
agriculture and forestry.
The adherence to the instructions
manual enclosed by Brill is
a requirement for the correct
usage of the appliance.
The instructions for use include
the operating maintenance and
repair conditions.
Caution! To avoid injury,
A
do not use the appliance
for the crushing of earthenware,
the turning over of lawns or
6. Assembly
Checking all the Parts are
Included
The box contains the following
parts:
Gardenboy
.
2 Spike-tooth discs with screws,
.
socket spanner with pin
Instruction manual
.
Environmental protection,
disposal
(pursuant to RL 2002 / 96 EC)
The packaging material
is made of recyclable
materials. Dispose of
packaging materials in
accordance with regu-
7. Putting into operation
Suspend the extension cable in
the mains lead strain relief (Figs.
8 and 9). This avoids an uninten-
tional loosening of the plug.
Insert the extension cable in the
mains socket. Always fully unreel
the cable reserve from the cable
drum and remove it from the
working area.
Hold the appliance with one
hand on the guide handle and
for the stirring or mixing of
liquids.
The appliance is only to be
A
used in soil which does not
contain stones.
Caution! Never allow chil-
A
dren or other people who
are not familiar with these oper-
ating instructions to use this unit.
Local regulations may specify
a minimum age for users of this
type of gardening equipment.
lations. Electrical appliances are
not to be disposed of in the nor-
mal household waste, they must
be professionally disposed of.
Important for Germany:
electrical appliances are to be
disposed of through your local
disposal sites.
Mounting the spike-tooth discs
(Fig. 6 and 7)
The enclosed spike-tooth discs,
the socket spanner with pins,
the screws and the split washers
for the spike-tooth discs are in
the insert in the lower part of the
packaging. Place the spike-tooth
discs on the square stud as
shown in figure 7. (Ensure that
the other on the intermediate
handle (Fig. 10).
To switch on, press the start but-
ton and keep it pressed (Fig. 11).
The appliance is switched off by
the start button being released
(Fig. 12).
A blocking of the motor results in
the clutch slipping. The appliance
can be immediately restarted
Remember that the user or oper-
ator is responsible for all acci-
dents that occur involving other
people or their property.
Only use approved PVC exten-
sion cables with the H05 VV-F
symbol or rubber with the
H05 RN-F symbol and a maxi-
mum cable length of 20 m and
a cross section of 3 x 1.5 mm
or a cross section of 3 x 2.5 mm
when using a cable length of
between 20 m and 50 m.
they are correctly positioned!).
Fix the spike-tooth discs in posi-
tion with the screws and split
washers. Tighten the screws
with the socket spanner enclosed
so that it is hand-screwed.
After each use, ensure that the
screws are firmly seated.
Ensure that all of the screws and
nuts are firmly tightened so that
the appliance is in a safe opera-
tional condition.
Caution! Only start the appliance
after it has been fully assembled!
after the cause of the blocking
has been removed. If the clutch
slips too often, you should alter
you working method as the
mechanical components could
otherwise be damaged.
Risk of injury if the
A
appliance does not switch
off automatically! Do not
remove or bypass safety
devices on the appliance
GB
2
2
19