Before The First Operation; Safety Cut-Out - Kalorik USK JK 32207 Manual De Instrucciones

Fax +1 305 430 9692

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or
•
before any operation.
Open the lid by holding its release button and fill the tank with
•
fresh water, paying attention not to fill under the minimum mark
and above the maximum mark on the water level indicator.
Close the lid by pressing it down until it you hear a click. Make
•
sure it closes correctly.
Make sure the spout filter is well in position, as else the auto-shut
•
off feature would not work.
Put the jug onto the power base, plug into the wall socket and
•
switch on. The pilot light of the switch will come on, indicating that
the appliance is operating. If it does not come on, check if the
kettle is correctly positioned on the base and check if the base is
plugged in. The jug kettle will switch off automatically when the
water has boiled. However, you can stop the jug kettle anytime by
putting the switch in off position.
For instant re-boiling, wait until water has cooled down and
•
switch on the appliance again.

SAFETY CUT-OUT

This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
In this case, switch off the appliance by putting the switch in OFF
•
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.
•
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special instruction from Team
Print only
USK JK 32207 JK 32850 - 120501