Publicidad
Idiomas disponibles
Idiomas disponibles
Using the adjustable spray wand
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
1. The washer is equipped with an adjustable nozzle.
2. The water pressure can be adjusted from low pressure (–)
to high pressure (+) by turning the pressure adjustment
knob. The nozzle tip can be adjusted from pencil spray
(wide open tip) to fan spray (narrow tip) by turning the
nozzle tip adjustment knob (Fig. 13).
Pressure
adjustment knob
Pencil spray
Nozzle tip
Nozzle tip
adjustment knob
Fig. 13
m
WARNING!
Do not adjust the nozzle while the trigger
is squeezed. Failure to do so could result in damage.
Recommended cleaning procedure
1. For additional cleaning power, a detergent spray
bottle attachment (Model SPX1DT) is available as an
add-on accessory for the SPX205E-MAX. Visit sunjoe.com
to purchase.
m
CAUTION!
Only use detergents specifically
recommended for use with pressure washers.
2. Load the bottle with a suitable, non-corrosive detergent
and attach it the spray gun (Fig. 14).
Fig. 14
Detergent spray bottle
(Model SPX1DT)
3. With the nozzle tip adjusted to a low-pressure fan spray,
apply detergent from the bottom to the top of the dry
surface to be cleaned. Applying detergent in this manner
will dissolve dirt most effectively.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
4. Allow the detergent to remain on the surface for a short
time before rinsing with the pressure washer. Do not allow
the detergent to dry on the surface.
Using the Wheel + Rim Brush
Sun Joe
®
and delicate surfaces. Compatible with all Sun Joe
pressure washers.
1. Disconnect the spray wand from the trigger gun by turning
the rotatable end-piece of the wand until the two parts are
completely unlocked (Fig. 15).
Fig. 15
Fan spray
2. Take the Wheel + rim brush and align the two tabs with the
inside of the extension lance (Fig. 16).
Fig. 16
3. Once aligned, push the Wheel + rim brush into the trigger
gun, twist counterclockwise to lock into place.
Shutting down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
10
Wheel + rim brush safely cleans painted, topcoat,
Locking tabs
Wheel + rim
brush
SPX series
®
Publicidad
