Home Decorators Collection 52-WWDO Manual De Instrucciones página 9

Assembly - Hanging the Fan
4
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to outlet box marked
"acceptable for fan support of 35 lbs. (15.9 Kg) or
less" using the screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide
into place on an outlet box with the outlet box screws
(HH) installed.
□
Pass the 120-Volt supply wires through the center hole in
the mounting bracket (A).
□
Install the ceiling mounting bracket on the outlet box by sliding
the mounting bracket (A) over the two screws (HH) provided
with the outlet box. If necessary, use leveling washers (not
included) between the mounting bracket (A) and the outlet box.
Note that the flat side of the mounting bracket (A) is toward
the outlet box. When using close-to-ceiling mounting, it is
important that the mounting bracket be level.
□
Securely tighten the two mounting screws (HH).
5
Hanging the fan
WARNING: The hook as shown is only to balance the
fan while attaching wiring. Failure to hang as shown
may result in hook breaking, causing the fan to fall.
The hook must pass from inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (XX) it
is critical that you use one of the non-slotted (round)
holes in the canopy (C).
□
Carefully lift the fan-motor assembly (D) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly into
the socket of the slide-on mounting bracket.
□
Turn the ball/downrod assembly clockwise until it is
seated with the tab of the slide-on mounting bracket
aligned with slot in the ball.
□
If using close-to-ceiling mounting, hang the fan on the
hook provided by utilizing one of the holes at the outer
rim of the ceiling canopy (C).
9
Please contact 1-800-986-3460 for further assistance.
Standard mount
A
B
C
K
D
Close to ceiling mount
A
C
K
D
HOMEDEPOT.COM/HOMEDECORATORS