Philips M 241068 Manual Del Usuario página 9

3 Get started
Installing the
NanoProtect filter
Before using the appliance, remove all
packaging materials of the filter and
place it into the appliance described as
follows:
Note
• Make sure that the side with the tag
is pointing towards you.
1
Pull the top part of the back panel
towards you to release it from the
appliance (fig. c).
2
Press the clip down and pull the
pre-filter towards you (fig. d).
3
Remove all filters (fig. e).
4
Remove all packaging materials of
the NanoProtect filter (fig. f) .
5
Place the NanoProtect filter back
into the appliance (fig. g).
6
Put the pre-filter back into the
appliance, mount the pre-filter onto
the bottom of the appliance first,
and then push the clips on the top
of pre-filter against the appliance
(fig. h).
7
To reattach the back cover, mount
the panel onto the bottom of the
appliance first, and then push
the top of the panel against the
appliance (fig. i).
All manuals and user guides at all-guidesbox.com
Preparing for
humidification
1
Pull out the water tank (fig. j).
2
Lift the water tray upwards and pull
it out horizontally (fig. k).
3
Remove all packaging material
of the NanoCloud rotary
humidification wick (fig. l).
• The humidification wick has been
assembled on the wick wheel upon
purchase.
4
Place the wick wheel on the wick
support (fig. m).
• When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
5
Place the water tray back into the
appliance (fig. n).
6
Turn the top cap of the water tank
anti-clockwise to unscrew it (fig. o).
7
Fill the water tank with cold tap
water (fig. p).
8
Turn the top cap clockwise to tightly
lock it onto the water tank (fig. q).
9
Place the water tank back into the
appliance (fig. r).
Note
Note
EN
7