Electrical Connection; Operating Your Refrigerator; Temperature Control - Premier NV-5260SS Manual De Instrucciones

This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is equipped with a three-prong
plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not left exposed or dangling to prevent accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician
install an outlet near the appliance. Use of an extension cord can negatively affect the performance of the unit.

OPERATING YOUR REFRIGERATOR

Temperature Control

Your refrigerator has one control for regulating the temperature. The
•
temperature control is located on the top left hand corner of the
refrigerator compartment.
The first time you turn the unit on, adjust the temperature control knob
•
to "MAX" and run for at least 2 hours before putting foods inside. This
will ensure the cabinet is thoroughly chilled before food is put in.
The range of the REFRIGERATOR temperature control is from position
•
"MIN" the warmest to "MAX" the coldest.
control to the setting that best suits your needs. The setting of "MED"
should be appropriate for home or office refrigerator use.
• NOTE;
If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart
•
before this time delay, the refrigerator will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
•
Do not place the foods on the air outlet, and leave spaces for airflow.
•
If you choose to change the thermostat setting, adjust thermostat control by one increment at a time. Allow several
•
hours for temperature to stabilize between adjustments.
Adjusting the temperature control in the refrigerator compartment will affect the temperature in both the refrigerator and
•
the freezer compartment.
Changing The Light Bulb
Before removing the light bulb, turn off the refrigerator first and then unplug the unit from the wall outlet. Failure to do so could
result in electrical shock or personal injury.
Use Phillips screwdriver to take out screw.
•
Remove the light cover by pulling downwards gently
•
Unscrew the bulb
•
Replace with a 15 watt-refrigerator bulb that is the sameshape and size.
•
Replace the light bulb cover and tighten screw.
•
•
P-4

Electrical Connection

Adjust the temperature