ADEO Services DM-130A1 Manual De Instrucciones página 90

Spanner
Sanding band
Collet
Felt wheel
Whet stone
6、ASSEMBLY
Locating and changing a tool.
While pressing the spindle lock button, rotate the clamping jaw

slowly until the button is fully depressed and engaged.
Never press the locking pin while the tool is running.
Press the locking pin and turn counter-clockwise to loose the collet nut.

Insert the shaft of the accessory into the collet. Always select the appropriate sized

collet for the bit being inserted. Ensure all tools are fully inserted, to reduce the risk
of bending an accessory, or excessive vibrations.
Press the locking pin and turn clockwise to lightly tighten the collet nut.

Locating disc accessories
Use the mandrel supplied.

 Insert the mandrel as per locating a tool ensuring the collet nut is tight and the
mandrel secure.
 Use the small screw on top of the mandrel to attach the disc.
 Do not over-tighten as this may damage the accessory.
7、OPERATION
Your mini grinder can be used for grinding and cutting. To get the best performance

from your tool please read the following guidelines.
Carbon steel
Φ12.7mm
Φ3.2mm
Φ21.5x5mm
Φ12.5x6mm
20x9.5x9.5mm
90
1
5
1
2
1