Introduction; Work Safety Instructions - CORNING Stripettor Ultra Manual De Instrucciones

1. Introduction

The pipet controller is a device intended for pipetting liquids with the use of measuring
pipets. It can work with all types of glass or plastic pipets in the volume range from 0.5 mL
to 100 mL.
Two dispense modes permit selection of dispensing intensity depending on the user's needs.
The selected setting of the pipet controller mode is shown on the display (Figure 1E).
Figure 1 shows the external parts of the pipet controller with a description of the materials
used.
Display indicators are shown in Figure 2.

2. Work safety instructions

WARNING! Risk of injury
CAUTION: Risk of damage to the device or errors in pipetting of liquids
Before starting the work with the pipet controller every user should read these operating
instructions carefully.
CAUTION:
• Using the device inconsistently with the operating instructions may result in damaging
the device.
• The device should be serviced only at an authorized service center, otherwise
the manu fac turer will be relieved from any liability under the warranty.
• Only original spare parts and accessories, recommended by the manufacturer, shall be
used.
• Only the original charger, supplied by the manufacturer, shall be used for charging
the batteries.
• In case of incorrect functioning of the pipet controller, work shall be stopped. The device
shall be cleaned according to section 9 and sent for repair to an authorized service center.
• In the case of mechanical damage to the casing, the device shall be immediately sent for
repair to an authorized service center.
• The use of excessive force during work shall be avoided.
WARNING!
• During the work with the pipet controller general safety regulations regarding risks related
with laboratory work should be observed. Protective clothing, goggles, and gloves should
be worn.
• The pipet controller shall be used only for measuring liquids in conditions specified
by the ma nufacturer, which are limited due to the chemical and mechanical resistance
of the device, as well as the user safety.
• The information and instructions provided by the manufacturers of the reagents must be
ob served.
Note: The pipet controller is equipped with liquid vapors exhaustion system which protects
against corrosion to ensure long instrument life.
2
ENGLISH