Hilti SIW 6 AT-A22 Manual De Instrucciones Original página 15

▶ On the intelligent torque module, set the correct type of anchor or threaded
stud to be fastened or the screw to be used (→ Operating instructions for
the intelligent torque module).
▶ When "AT" lights in the torque display, the torque selector switch is
inoperative. Speed and torque are regulated by the torque module.
5.2 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
5.2.1 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired direction of rotation.
▶ An interlock prevents switching while the motor is running.
▶ The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
5.2.2 Switching on
▶ Press the control switch.
When operated without the intelligent torque module: Speed of
rotation is regulated by the travel of the control switch.
When operated with the intelligent torque module: The control switch
works only as an on/off switch and the speed of rotation is controlled
via the intelligent torque module.
5.2.3 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be
damaged if torque is too high. This presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced
by the tool.
Conditions: Operation without the intelligent torque module
1. Move the forward/reverse switch into the middle position.
2. Use the torque selector button to set the desired torque. → page 10
*2124662*
2124662
4
English 11