Descargar Imprimir esta página

EuroLite LED QMS-8 RGB Manual Del Usuario página 19

Efecto de luz

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Music Controlled Operation
Select che9 and adjust the audio input level using the sensitivity control dial on the side panel of the
controller.
DMX-controlled operation
You can control the devices individually via your DMX-controller.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED QMS-8 RGB will respond to the controller.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
Controlling:
After having addressed the LED QMS-8 RGB, you may now start operating it via your lighting controller.
Note:
After switching on, the LED QMS-8 RGB will automatically detect whether DMX 512 data is received or not.
If the data is received, the control LED flashes. If there is no data received at the DMX-input, the control LED
lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED
QMS-8 RGB.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
L I
Control channel 1 – Each device occupies 12 channels. Four devices occupy 48 channels.
L2
Control channel 2 – Each device occupies 6 channels. Four devices occupy 24 channels.
CH
CH
CH
1-12
13-24
25-36
CH
CH
CH
1-6
7-12
13-18
19/39
CH
37-48
CH
19-24
51930260_V_1_1.DOC

Publicidad

loading