SpeedEPart 45-512-100 Manual Del Usuario página 7

17. For most vehicles, you can keep the assembled hitch
extension bracket in its default position shown in figure
11. A ttach the spreader hitch to your vehicle hitch. Check
for interference with the spreader directly behind and
out to both sides of the vehicle. Lift the spreader at each
position to make sure there is no interference with the
spreader's flow control. If there is interference with the
rear of the vehicle, assemble the hitch extension bracket
as shown at the bottom of figure 11. Tighten the bolts
and nuts when finished.
DEFAULT POSITION
FIGURE 11
ENGLISH
EXTENDED
(IF INTERFERENCE)
7