MANUAL
A
INSTALLING THE HEATER
B
Carefully remove your Zibro heater from the box and check the contents.
1
In addition to the heater you also need to have:
a manual fuel pump
a transportation cap
these directions for use
C
Keep the box and the packaging materials (Fig. A) for storage and/or transportation.
Remove the other packaging materials:
2
Remove the packaging material from the grill ¶. Lift the grill from the slot
(Fig. B) and pull it forward.
Push the packing material on top of the combustion chamber ¿ slightly
D
down and remove it (Fig. C). Remove the packaging materials from under
the combustion chamber as well (Fig. D).
Put the combustion chamber back into its place. The combustion chamber
is positioned correctly when it can be smoothly moved a little to the left
and to the right by its handle ´ (Fig. E). Close the grill: Slightly lift it to
reposition it in its slot.
E
Open the lid for removable tank º and remove the piece of cardboard.
Fill the removable tank as indicated in Section B.
3
Insert the batteries into their holder ¹ at the back of the heater (Fig. F).
4
Ensure that the positive and negative poles match the + and - marks indicated
F
on the battery housing.
5
The floor should be firm and completely level. Please refer to the separate
instructions in the carton box for fixing of the heater.
Your heater is now ready for use.
6
G
B
FILLING FUEL
Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
Make sure that the heater is switched off.
1
Open the lid º and lift the removable tank ¾ out of the heater (Fig. G).
2
Note: Some drops may leak from the tank. Put down the removable tank
(cap pointing upwards) and screw off the fuel cap.
4
53