Descargar Imprimir esta página

Jonsered CS 2250S II Manual De Usuario página 21

Ocultar thumbs Ver también para CS 2250S II:

Publicidad

Idiomas disponibles

Idiomas disponibles

To cut trees and branches that are in tension
1. Figure out which side of the tree or branch that is in
tension.
2. Figure out where the point of maximum tension is.
3. Examine which is the safest procedure to release the
tension.
Note:
In some situations the only safe procedure
is to use a winch and not your product.
4. Keep a position where the tree or branch can not hit
you when the tension is released.
5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING:
through a tree or branch that is in
tension.
WARNING:
you cut a tree that is in tension. There is
a risk that the tree moves quickly before
or after you cut it. Serious injury can
occur if you are in an incorrect position
or if you cut incorrectly.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
1049 - 005 - 21.06.2021
Do not cut straight
Be very careful when
Maintenance
Read and understand the
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION:
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of the air intake on the starter. This
increases the engine temperature.
2. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
CAUTION:
the temperature increases above -5°C/23°F.
Assemble the plug in the cylinder cover if
the temperature increases above 0°C/32°F.
Risk of too high engine temperature and
damage to the engine.
Snow and cold weather can
Remove the winter cover if
21

Publicidad

loading

Este manual también es adecuado para:

Cs 2245s iiCs 2245 ii