Jonsered CS 2250S II Manual De Usuario página 34

The engine starts but stops again
Product part to examine
Fuel tank
Carburetor
Air filter
Fuel filter
Transportation and storage
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for storage and
transportation of fuel.
• Empty the fuel and chain oil tanks before
transportation or before long-term storage. Discard
the fuel and chain oil at an applicable disposal
location.
• Use the transportation guard on the product to
prevent injuries or damage to the product. A saw
chain that does not move can also cause serious
injuries.
• Remove the spark plug cap from the spark plug and
engage the chain brake.
• Attach the product safely during transportation.
Technical data
Engine
Cylinder displacement,
3
cu.in/cm
Idle speed, rpm
Maximum engine power
acc. to ISO 8893, kW/hp @
rpm
1
Ignition system
1
Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.
34
Possible cause
Incorrect fuel type.
The idle speed is not correct.
Clogged air filter.
Clogged fuel filter.
Transportation and storage
Technical data
Jonsered CS 2245 II
2.79/45.7
2700
2.1/2.8 @ 9000
Action
Drain the fuel tank and fill with cor-
rect fuel.
Speak to your servicing dealer.
Clean or replace the air filter.
Replace the fuel filter.
To prepare your product for long-term
storage
1. Stop the product and let it become cool before you
disassemble it.
2. Disassemble and clean the saw chain and the
groove in the guide bar.
CAUTION:
guide bar are not cleaned, they can
become rigid or blocked.
3. Attach the transportation guard.
4. Clean the product. Refer to
for instructions.
5. Do a complete servicing of the product.
Jonsered CS 2245S II
2.79/45.7
2700
2.1/2.8 @ 9000
If the saw chain and
Maintenance on page 21
Jonsered CS 2250S II
3.06/50.2
2700
2.4/3.2 @ 9000
1049 - 005 - 21.06.2021