Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-2116-003.book Page 26 Monday, September 5, 2016 5:52 PM
26 | English
Transferring Angles (see figure C)
Measure the angle to be transferred by applying the base leg and the fold-
out leg to the reference angle.
Place the measuring tool in the desired position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Ensure that the fold-out and base legs are not moved during transfer.
Marking Angles (see figure D)
Open the fold-out leg and the base leg until the required angle is indicated
in the display a.
Place the measuring tool in the desired position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Storing the Measured Value ("Hold/Clear")
To store the current measured value ("Hold"), press the "Hold/Clear"
memory button 9.
The measured value is displayed until you press the "Hold/Clear" memory
button 9 again, regardless of any movements of the base and fold-out legs.
Measuring with Leg Extension (see figures F–H)
The leg extension 2 makes it possible to measure angles when the contact
surface is shorter than the fold-out leg 1.
Mount the leg extension 2 (see "Mounting the Leg Extension", page 24).
Place the base leg 3 and the leg extension flat on the surfaces adjacent to
the angle.
The reading of the angle w between base leg and fold-out leg is indicated in
the display. The required angle v between base leg and leg extension is cal-
culated as follows:
v = 180° – w
1 609 92A 1XZ | (5.9.16)
Bosch Power Tools
Publicidad
