Fanimation EIGHTYFOUR LP6827 Manual Del Usuario página 14

How to Assemble Your Light Kit (Continued)
4. Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from the
motor assembly. (Figure 4)
5. Assemble the LED assembly to the switch housing
assembly using the two key slots. Replace the
removed screw from Step 3 and secure all three
screws. (Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
6. Secure the glass to switch housing assembly by
twisting in a clockwise direction. Twist the glass
until it snaps onto the switch housing
gradually
assembly
. Do not over-tighten. (Figure 6)
1. IMPORTANT: Using a full range dimmer switch (not
included) to control fan speed will damage the fan. To
reduce the risk of fire or electrical shock, do not use a
full range dimmer switch to control the fan speed.
(Figure 1)
How to Operate Your Ceiling Fan
Motor Assembly
LED Assembly
Switch Housing
Assembly
LED Assembly
Switch Housing
Assembly
Glass
For illustrative purposes only-not
intended to cover all types of controls
14
Figure 4
Figure 5
Figure 6
Figure 1