FUNCTIONS OF OPERATION SWITCH
PANEL
1. TACKING STITCH MODE BUTTON
Press Tacking Stitch
tiny fixing stitches to tie off the sewing on all patterns. Press
START/STOP to sew.
Press Tacking Stitch button when the machine is stopped
so tacking stitch will be activated, the position of the tacking
stitches will be at the exact spot in the pattern where the
Tacking Stitch button is pushed. When the function is
activated, the LED indicator next to the button is lit red.
2. THREAD CUTTER
Press Thread Cutter to automatically cut the top and bobbin
threads.
3. NEEDLE STOP POSITION SELECTOR BUTTON
When the machine is turned on, needle is set at its up-stop
position with upper LED lamp lit. When the button is pushed,
needle is set at its down-stop position with lower LED lamp
lit. Push it again and it will return to its up-stop position with
upper LED lamp lit.
4. REVERSE STITCH BUTTON
Reverse sewing is carried out by pushing the reverse stitch
button. The machine will sew 4 stitches in reverse and stop.
5. START/STOP BUTTON
When the Start/Stop button is pushed, the machine starts
slowly, and when the button is pushed once more, the
machine stops.
However, when foot control is plugged, the Start/Stop button
will be inactive.
6. LED INDICATOR
Green light indicates machine is ready to start.
Red light indicates machine is operating.
Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* C o n t i n u o u s f l a s h i n g i n d i c a t e s t h a t t h e m a c h i n e
malfunctions.
7. SPEED CONTROL LEVER
Sliding the lever sets desired sewing speed. When foot control
is used, the lever serves as a top speed limiter.
30
and the sewing machine makes 4
1
6
Reverse stitch function
for straight and zigzag
stitches
Fonction couture
arrière pour les points
droits et zigzags
Función de costura
hacia atrás para
costuras rectas y
zigzag
Tacking stitch function
for tie-off of other
stitches
Fonction de point
de faufilage pour la
jonction avec d'autres
points
Función de remate
para terminación de
otras puntadas.
2
3
4
5
7