Hansgrohe AXOR Starck 240 1-Jet 12672 Serie Instrucciones De Montaje / Manejo / Garantía página 2

T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate @ 44 PSI (0.3 MPa)
12672XX1
showerhead
handshower
12673XX1
showerhead
handshower
I NSTALL ATI ON CO NS ID ER ATI ONS
Inspect the showerpipe for shipping damage
before installation. Claims for shipping dam-
age made after the showerpipe is installed
will not be honored.
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ This showerpipe requires rough valve 10902181(not
included).
⁄ Protection against backflow is provided by check
valves.
⁄ Do not install this showerpipe in a steam shower.
⁄ Make sure that the wall is strong enough to support
the showerpipe. The wall must be reinforced at the
mounting points. The area where the top mount-
ing piece is to be installed must be flat and free of
protruding grout joints, etc.
⁄ The enclosed screws and anchors are suitable for a
solid surface wall. For other wall constructions, select
mounting hardware and reinforcement suitable for
that specific construction.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
2.5 GPM (9.5 l/min)
2.5 GPM (9.5 l/min)
1.75 GPM (6.6 l/min)
1.75 GPM (6.6 l/min)
E N G L I S H
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
⁄ The thermostatic mixing valve is for use with shower
heads rated at 1.3 GPM (4.9 l/min) or higher.
⁄ 12672XX1 ONLY: The showerhead and handshow-
er are for use with an automatically compensating
valve rated at 1.9 GPM (7.2 l/min) or lower.
⁄ 12673XX1 ONLY: The showerhead and handshow-
er are for use with an automatically compensating
valve rated at 1.3 GPM (4.9 l/min) or lower.
⁄ To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher than
120°F (49°C). In Massachusetts, the maximum
output temperature can be no higher than 112°F
(44°C).
This showerpipe must not be used as a grab
bar. If a grab bar is required, install one
separately.
The shower arm is intended to hold the
showerhead only. Do not use it to hold other
objects.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a
safe place. The receipt is required should it be neces-
sary to request warranty parts.