Publicidad
Idiomas disponibles
Idiomas disponibles
FUNCTIONAL DESCRIPTION
5
4
2
3
1. Power button
Pre-Heat: Red LED fades on and off
High: Red LED continuous
Medium: White LED continuous
Low: Blue LED continuous
2. Battery holder
3. Power cable port
4. Battery holder pocket
5. Power cable
ASSEMBLY
WARNING
charger specifi ed for the battery. For specifi c
charging instructions, read the operator's man-
ual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body
of the battery holder. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
holder pocket) into the power cable port on the
battery holder.
Place the battery holder into the pocket and zip
closed.
To remove the battery, push in the release buttons
and pull the battery pack away from the holder.
OPERATION
To turn on, press and hold the heated jacket power
button (about 3 seconds). The heated jacket will
begin to preheat (5 minutes) and then adjust to
the medium setting.
Temperature setting can be adjusted at any time
by pressing the heated jacket power button. Each
press will cycle through the heated jacket's tem-
perature settings.
To turn off the heated jacket, press and hold the
heated jacket power button until the LEDs turn off
(about 3 seconds).
If the heated jacket turns off unexpectedly, check
connections and charge the battery pack.
1
M12
Recharge only with the
WARNING
always unplug the charger and remove
the battery pack and battery holder from
the heated jacket before performing any
maintenance. Never disassemble the heated
jacket, battery pack or charger. Contact a
MILWAUKEE service facility for ALL repairs.
If the heated jacket does not start or operate
properly with a fully charged battery pack, clean
the contacts on the battery pack. If the heated
jacket still does not work properly, return the heated
jacket, charger and battery pack, to a MILWAUKEE
service facility for repairs.
WARNING
injury and damage, disconnect and re-
move battery pack and battery holder from
battery holder pocket before washing. Never
immerse your battery holder, battery pack,
or charger in liquid or allow a liquid to fl ow
inside them.
To clean the heated jacket:
1. Remove battery pack and battery holder.
2. Hand wash heated jacket in cold water. Do not
use bleach. Do not wring. Do not machine wash
even though machine may include a hand wash
or equivalent cycle.
3. Hang dry. Do not machine dry. Do not iron.
ACCESSORIES
WARNING
pack before changing or removing ac-
cessories. Only use accessories specifi cally
recommended for this tool. Others may be
hazardous.
For a complete listing of accessories refer to your
MILWAUKEE Electric Tool catalog or go online
to www.milwaukeetool.com. To obtain a catalog,
contact your local distributor or service center.
3
CARE
To reduce the risk of injury,
To reduce the risk of personal
Always remove battery
Publicidad
