VelLight LEDC25 Manual Del Usuario página 5

Respect a minimum distance of 0.5 m between the device's light output

and any illuminated surface.

The maximum ambient temperature is 40 °C. Do not operate the device
at higher temperatures.
3. General Guidelines
Refer to the Velleman
of this manual.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force
when operating the device.

Familiarise yourself with the functions of the device before actually
using it. Do not allow operation by unqualified people. Any damage that
may occur will most probably be due to unprofessional use of the
device.

All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the
warranty.

Only use the device for its intended purpose. All other uses may lead to
short circuits, burns, electroshocks, lamp explosion, crash, etc. Using
the device in an unauthorised way will void the warranty.

Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.

A qualified technician shall install and service this device.

Do not switch the device on immediately after it has been exposed to
changes in temperature. Protect the device against damage by leaving
it switched off until it has reached room temperature.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features
A DMX controller to use with digital LED strips. It converts the DMX-512
signal to SPI (TTL) signal.
This controller allows you to control each LED separately via a DMX
controller or professional DMX console.

compatible with: digital LED strip with grey scale IC
LQ12N210DRGB
o
V. 02 – 22/10/2015
LEDC25
®
Service and Quality Warranty on the last pages
5 ©Velleman nv