Publicidad
Idiomas disponibles
Idiomas disponibles
WellMag
6
1
1
Display LCD
2
(I) = ON/OFF: turn on / turn off
3
Cursor up/down
4
(+)/(-) : intensity regulation
5
Output for applicators cable
6
Cable Output
NOTE: before applying the magnetotherapy, check the contraindications and
consult the physician that prescribed the therapy.
6
CAP4 - Operation
2
4
3
CAP4 - Operation
Connect the cable of the solenoids to the output of the device. Insert, rotate and
tighten the connector into the output. Solenoids must be placed on the area to be
treated (they can be applied on the top of stockings or cloths) and can be fixed with
the elastic straps. The plain side on the solenoids must be placed in contact with the
area to be treated.
WELLMAG offers magnetotherapy treatments at low and high frequency. For high
frequency (program 31H), it is mandatory to use WELLMAG with Easycare band or with
any optional accessories for high frequency. Solenoids CANNOT be used. For the other
low frequency programs (from P01 to P30), solenoids can be used.
You can use WELLMAG with battery or with power supply (230V), connecting the
power supply to the device and to the AC mains.
Press key (2) - ON/OFF.
5
When turning on the device, the section programs (PROG) is displayed.
WELLMAG offers:
- 30 preset LOW FREQUENCY programs (from N.1 to N.30), identified by letter P. These
can only be used with solenoids or low frequency accessories;
- 5 adjustable programs identified by letter U. You can save here programs in low
frequency, prescribed by your doctor.;
- 1 HIGH FREQUENCY program (N.31 HF) , that has an antalgic effect thanks to its
automatic scanning mode. This program can be used with the Easycare band or
with high therapy accessories (Cap14);
To select the desired program, use the keys (+)/(-).
4.1 - Connection and application of solenoids
4.2 - WELLMAG operating with band EasyCare
4.3 - Power source
4.4 - Turning on the device
4.5 - Program selection
WellMag
7
Publicidad
