Publicidad
Idiomas disponibles
Idiomas disponibles
WellMag
4.10 - End or interruption of the session
If you want to stop the device before the program ends, press the key (2) PAUSE once
for a break (to continue press (2) START); hold pressing (2) PAUSE to end the therapy
(the device will turn off)
To turn off the instrument press and hold the key (2) ON/OFF for some seconds. After
the end of a program, if the device is not used again, it automatically turns off after a
few minutes.
4.12 - Symbols on display
MAINS FEEDING: power suppy through electrical power
(charger connected).
Connected solenoid
BATTERY feeding with charge level
4.13 - Verification of the solenoids operation
Magnetotherapy cannot be
detected, therefore a magnet
is provided with the device, in
order to check its functioning.
Please proceed to the test
below:
10
CAP4 – Operation
4.11 - Turning off the device
CAP4 – Operation
1.
Connect the solenoids cable to the device
2.
Hold the magnet between fingers to put it on the top of the solenoid
3.
Turn on the device and start program P10
4.
If the device is working properly, you will notice the magnet vibrating between
fingers. This is due to the continuous polarity inversion on the solenoids.
If you want to feel a stronger vibration, increase intensity of P10.
5.
Run the same test on the other solenoid
NOTE:
Run the test with P10 program as this is where the vibration is felt the most.
If working with this program, it will also with the other programs.
NOTE:
the magnet is only working when using solenoids and low frequency programs.
It cannot be used with Easycare band (magnet cannot detect high frequency)
CAP5 - Free programs
CAP3 – Dotazione di base e accessori
5.1 - Setting of free program
To access to the setting from PROG menu area use the keys (+)/(-) and go to the
U programs. Use the keys
and
parameters as desired with the keys (+)/(-). Once the parameters have been selected,
press key 2 START to start the selected therapy. When the devices will be turned off
the program will be saved.
NAME ON DISPLAY
PARAMETER
Freq.
Frequency of the impulse
Inten
Intensity
Time
Program Duration
To help you choosing the setting in the free programs, please check the guidelines
below: in the first column you find the available parameters with the corresponding
values, while in the second column you find the corresponding type of application.
NOTE: if, after having chosen a program, you want to change to another one, you need
to turn off the device with key (2) OFF and turn on again with key (2) ON
WellMag
WellMag
to go to INTEN, FREQ, TIME menu. Change the
AVAILABLE VALUES
1-200 step 1 Hz
1-100G
5 minutes to 8 hours
11
Publicidad
