Toro Flex-Force Power System 60 Manual Del Operador página 20

Problem
The LED indicator light
on the battery charger is
blinking red.
The tool does not run or
does not run continuously.
Possible Cause
1. There is an error in
the communication
between the battery
pack and the charger.
2. The battery pack is
weak.
1. There is moisture on
the leads of the battery
pack.
2. The battery is not fully
installed into the tool.
18
Corrective Action
1. Remove the battery
pack from the battery
charger, unplug the
battery charger from
the outlet, and wait
10 seconds. Plug the
battery charger into the
outlet again and place
the battery pack on the
battery charger. If the
LED indicator light on
the battery charger is
still blinking red, repeat
this procedure again.
If the LED indicator
light on the battery
charger is still blinking
red after 2 attempts,
properly dispose of the
battery pack at a battery
recycling facility.
2. Properly dispose of the
battery pack at a battery
recycling facility.
1. Allow the battery pack
to dry or wipe it dry.
2. Remove and then
replace the battery into
the tool making sure
that it is fully installed
and latched.