Chauvet Professional ROGUE R2X BEAM Guía De Referencia Rápida página 4

EN
DMX Linking
The Rogue RX2 Beam will work with a DMX controller using a 3- or 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Rogue RX2 Beam uses a 3- or 5-pin DMX data connection for its 2 DMX personalities. See the User Manual for
information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Rogue RX2 Beam supports RDM protocol that allows feedback to make changes to menu map
options. Download the User Manual from
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/
Product Mounting Diagram
Overhead Mounting
Control Panel Description
Button
<MENU>
<ENTER>
<UP>
<DOWN>
3
QUICK REFERENCE GUIDE
www.chauvetprofessional.com
Safety Notes. Use at least one mounting point per product. Make sure the
Safety Cable
Mounting Clamp
Omega Bracket
Exits from the current menu or function
Enables the currently displayed menu or sets the currently selected value into the
selected function
Navigates upwards through the menu list or increases the numeric value when in a
function
Navigates downwards through the menu list or decreases the numeric value when in a
function
for more details.
Floor Mounting
Function
Rogue R2X Beam QRG Rev. 1