Publicidad
Idiomas disponibles
Idiomas disponibles
Before each use
• Always wear appropriate protective gear, including eye protection, steel-toed shoes, and well-fitting
gloves without drawstrings or loose cuffs.
• Do not wear loose or sagging clothing.
• Before splitting, check the logs and remove nails or other foreign objects.
• Remove all branches from the log before splitting.
• Before use, check the general technical condition of the device.
3.4.
Working with the device
Place the machine on a flat and level surface. The machine will vibrate during operation, so make
1)
sure the front support is attached to the body to ensure stability.
NOTE: The machine can work properly only when the protective net is in place.
2) The handles must be in the starting position. Check that all moving parts are fully operational.
Before starting work, make sure that the distributor's head is not blocked and that the pusher
piston can smoothly extend.
3) Lay a piece of wood flat on the work table with one end facing the blade. Use caution! The pieces
of wood should be arranged according to the figure below.
Correct position
4) Move the safety lever with one hand, and move the control lever with the other hand. The piston
will quickly move forward and split a piece of wood. Move the control lever in the opposite
direction, the spring will make the plunger immediately return to its original position, and the
machine will be ready to split the next piece of wood. The machine can only be operated by one
person at a time. After placing the log on the work table, keep both hands on the levers at all
times.
5) The movement of the control lever should be done quickly and decisively to achieve better and
smoother gear meshing.
6) If the wood is not split on the first attempt, quickly disconnect the pinion and pinion shaft, (retract
the control lever) to return the pusher plunger to position, wait until the device stabilizes, and
then try splitting the wood again.
7) If the log cannot be split after 3 attempts, try splitting at a different angle or cutting the log to a
smaller size.
8) Move the split wood away from the work area and repeat the procedure to split another piece of
wood.
3.5.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use. Wait until the rotating parts stop.
Incorrect position
Publicidad
