Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
Your AC/DC ARC WELDER has many features
that will make your job faster and easier. Safe-
ty, performance and reliability have been given
top priority in the design of this tool, qualities
to make easy to maintain and to operate.
WARNING: Carefully read the entire man-
ual before attempting to use this tool. Be sure
to pay special attention to the safety rules and
all the Warnings and Cautions of this manual.
GENERAL SAFETY RULES
WARNING: Read and understand all instruc-
tions. Failure to follow all indications listed
below, may result in electric shock, fire and/or
serious personal injury.
SAVE THESE INSTRUCTIONS.
WORK AREA
• Keep your work area clean and well lit. Clut-
tered benches and dark areas may cause acci-
dents.
• Do not operate power tools in explosive at-
mospheres, such as in the presence of flamma-
ble liquids, gases or dust. Power tools create
sparks which may provoke fire.
• Keep away observers, children and visitors
while operating a power tool. Distractions can
cause you to lose control.
• Precaution must be taken to keep the opera-
tor and the machine from the foreign materi-
als falling from up above.
• The dust, acid and erodible dirt in the air
at the job site can not exceed the amount re-
quired by the norm (excluding the emission
from the welding process).
• Inflammable or explosive materials are pro-
hibited to access the job site.
• The welder must be installed in the place
where it can not be exposed to sun or rain.
Also it must be stored in less humid place with
the temperature rage at 10 and 40oC.
• There should be 50 cm space for the welding
machine to have good ventilation.
• Make sure that there is no metal-like foreign
body to enter the welding machine.
• No violent vibration in the welder's surround-
ing area.
E N G L I S H
• Take measures to prevent wind while op-
erating in the strong wind since the welder
is gas shielded. The wind speed is limited be-
low 1.0m/s, or the wind shield device must be
loaded.
PERSONAL SAFETY
• Please always follow the rules that conform
to safety and hygiene.
• Wear protective garments to avoid injuries
to eyes and skins.
• Use the welding helmet to cover your head
while working with the welding machine. Only
by viewing through the filter lens on the weld-
ing helmet can you watch your operation.
• Under no circumstance can you allow any
part of your body to touch the welder's output
bipolarity (torch and work piece).
ATTENTION: No switching on the voltage ad-
justment when welding.
• Check the connection to see if the welder
input and output cables are well connected,
whether the earth (ground) connection is reli-
able, etc.
• No flammable or explosive items be in the
welding site.
• Fumes and gases produced when welding
are hazardous to health. Make sure to work in
places where there are exhaust or ventilation
facilities to keep fumes or emissions away from
the breathing zone.
• Please remember to keep arc rays away from
the other nearby people when welding. This is
only due to the interference from arc rays.
• Never allow anybody else other than the
operator himself to dislocate or modulate the
welding machine.
REMOTE OPERATION
Should take into consideration the following
precautionary measures since the distance be-
tween the operator and welding equipment in
remote locations can cause the operator can
not monitor or cable equipment.
• Extend the cable length Welding equipment
to prevent ov heating.
• Strengthen protection equipment Welding
wire and cable remote to avoid being crushed,
bruised or otherwise damaged.
U ser 's M anu al
9
Publicidad
Tabla de contenido
